Tektronix Keithley SourceMeter 2470

Section
13: Introduction to TSP commands 2470 High Voltage SourceMeter Instrument
Reference Manual
13-50 2470-901-01 Rev. A / May 2019
Status model
The status model is a set of status registers and queues. You can use the following commands to
manipulate and monitor these registers and queues to view and control various instrument events.
status.clear() (on page 14-179)
status.condition (on page 14-179)
status.operation.condition (on page 14-181)
status.operation.enable (on page 14-181)
status.operation.event (on page 14-182)
status.operation.getmap() (on page 14-183)
status.operation.setmap() (on page 14-183)
status.preset() (on page 14-184)
status.questionable.condition (on page 14-185)
status.questionable.enable (on page 14-185)
status.questionable.event (on page 14-186)
status.questionable.getmap() (on page 14-187)
status.questionable.setmap() (on page 14-187)
status.request_enable (on page 14-188)
status.standard.enable (on page 14-189)
status.standard.event (on page 14-191)
Time
bufferVar.fractionalseconds (on page 14-25)
bufferVar.n (on page 14-26)
bufferVar.relativetimestamps (on page 14-29)
bufferVar.seconds (on page 14-30)
bufferVar.times (on page 14-38)
bufferVar.timestamps (on page 14-39)
delay() (on page 14-51)
localnode.gettime() (on page 14-89)
timer.cleartime() (on page 14-192)
timer.gettime() (on page 14-192)
trigger.timer[N].clear() (on page 14-251)
trigger.timer[N].count (on page 14-252)
trigger.timer[N].delay (on page 14-253)
trigger.timer[N].delaylist (on page 14-254)
trigger.timer[N].reset() (on page 14-256)
trigger.timer[N].start.fractionalseconds (on page 14-257)
trigger.timer[N].start.generate (on page 14-257)
trigger.timer[N].start.overrun (on page 14-258)
trigger.timer[N].start.seconds (on page 14-259)
trigger.timer[N].start.stimulus (on page 14-259)
trigger.timer[N].wait() (on page 14-261)
tspnet.timeout (on page 14-284)