High Voltage SourceMeter Instrument Reference Manual Section 12:
2470-901-01 Rev. A / May 2019 12-9
*RCL
This command returns the instrument to the setup that was saved with the *SAV command.
Type Affected by Where saved Default value
Usage
*RCL <n>
An integer from 0 to 4 that represents the saved setup
Details
Restores the state of the instrument from a copy of user-saved settings that are stored in setup
memory. The settings are saved using the *SAV command.
If you view the user-saved settings from the front panel of the instrument, these are stored as scripts
named Setup0<n>.
Example
Restores the settings stored in memory location 3.
Also see
Saving setups (on page 3-45)
*SAV (on page 12-9)
*SAV
This command saves the present instrument settings as a user-saved setup.
Type Affected by Where saved Default value
Command only Not applicable Nonvolatile memory Not applicable
Usage
*SAV <n>
Details
Save the present instrument settings as a user-saved setup. You can restore the settings with the
*RCL command.
Any command that is affected by *RST can be saved with the *SAV command.
You can save up to five user-saved setups. Any settings that had been stored previously as <n> ar
e
overwritten.
If you view the user-saved setups from the front panel of the instrument, they are stored as scripts
named Setup0<n>.
To Next Page
Loading...
Need help?
General
