High Voltage SourceMeter Instrument Reference Manual Section 14:
2470-901-01 Rev. A / May 2019 14-159
smu.source.delay
This attribute contains the source delay.
Type TSP-Link accessible Affected by Where saved Default value
Attribute (RW) Yes Restore configuration
Instrument reset
Power cycle
Source configuration list
Function change
Configuration script
Source configuration list
Not applicable
Usage
sDelay = smu.source.delay
smu.source.delay = sDelay
The length of the delay (0 to 10 ks)
Details
This command sets a delay for the selected source function. This delay is in addition to normal
settling times.
After the programmed source is turned on, this delay allows the source level to settle before a
measurement is made.
If you set a specific source delay (smu.source.delay), source autodelay is turned off.
When source autodelay is turned on, the manual source delay setting is overwritten with the
autodelay setting.
When either a source delay or autodelay is set, the delay is applied to the first source output and then
only when the magnitude of the source changes.
Example
smu.source.func = smu.FUNC_DC_VOLTAGE
smu.source.delay = 3
Set the function to voltage. Set a 3 s delay
after the source is turned on before a
Also see
smu.source.autodelay (on page 14-152)
Source delay (on page 4-45)
To Next Page
Loading...
Need help?
General
