High Voltage SourceMeter Instrument Reference Manual Section 13:
Introduction to TSP commands
2470-901-01 Rev. A / May 2019 13-43
Display
The display functions and attributes allow you to change the format of information on the front-panel
display of the instrument. You can also customize your display.
display.changescreen() (on page 14-57)
display.clear() (on page 14-58)
display.delete() (on page 14-58)
display.input.number() (on page 14-59)
display.input.option() (on page 14-61)
display.input.prompt() (on page 14-63)
display.input.string() (on page 14-64)
display.lightstate (on page 14-66)
display.prompt() (on page 14-67)
display.readingformat (on page 14-68)
display.settext() (on page 14-69)
display.waitevent() (on page 14-70)
Event log
You can use the event log to view specific details about LAN triggering events.
eventlog.clear() (on page 14-71)
eventlog.getcount() (on page 14-71)
eventlog.next() (on page 14-72)
eventlog.post() (on page 14-74)
eventlog.save() (on page 14-75)
File
You can use the file commands to open and close directories and files, write data, or to read a file on
an installed USB flash drive.
The root folder of the USB flash drive has the absolute path:
"/usb1/"
You can use either the slash (/) or backslash (\) as a directory separator. However, the backslash is
also used as an escape character, so if you use it as a directory separator, you will generally need to
use a double backslash (\\) when you are creating scripts or sending commands to the instrument.
To Next Page
Loading...
Need help?
General
