Tektronix Keithley SourceMeter 2470 Reference Manual

2470
High Voltage SourceMeter Instrument Reference Manual Section 14:
TSP command reference
2470-901-01 Rev. A / May 2019 14-21
bufferVar.endindex
This attribute indicates the last index in a reading buffer.
Type TSP-Link accessible Affected by Where saved Default value
Attribute (R)
Yes
Restore configuration
Instrument reset
Power cycle
Not applicable
Not applicable
Usage
bufferVar.endindex = endIndex
endIndex
Ending index of the buffer
bufferVar
The name of the reading buffer, which may be a default buffer (defbuffer1 or
defbuffer2) or a user-defined buffer
Details
Use this attribute to find the ending index in a reading buffer.
Example
test1 = buffer.make(100)
smu.measure.count = 6
smu.measure.read(test1)
print(test1.startindex, test1.endindex, test1.capacity)
smu.measure.read(test1)
print(test1.startindex, test1.endindex)
Create a buffer named test1 with a capacity of 100 readings.
Set the measure count to 6.
Make measurements and store them in buffer test1.
Get the start index, end index, and capacity of test1.
Output:
1, 6, 100
Make six more measurements and store them in buffer test1.
Get the start index and end index of test1.
Output:
1, 12
Also see
bufferVar.startindex (on page 14-36)
buffer.make() (on page 14-12)
Reading buffers (on page 6-1)
Remote buffer operation (on page 6-25)

Tektronix Keithley SourceMeter 2470 Specifications

General

Brand	Tektronix
Model	Keithley SourceMeter 2470
Category	Measuring Instruments
Language	English