To Next Page

To Previous Page

Section

14: TSP command reference 2470 High Voltage SourceMeter Instrument

Reference Manual

14-98 2470-901-01 Rev. A / May 2019

Details

From a remote node, use this function to assign the given value to a global variable.

Do not use this command to create or set the value of a global variable from the local node (set the

global variable directly instead). This command should only be used from a remote master when

controlling this instrument over a TSP-Link

Example

node[3].setglobal("x", 5)

Sets the global variable

on node 3 to the value of 5.

Also see

node[N].getglobal() (on page 14-97)

opc()

This function sets the operation complete (OPC) bit after all pending commands, including overlapped commands,

have been executed.

Type TSP-Link accessible

Affected by Where saved Default value

Function

Usage

opc()

Details

This function causes the operation complete bit in the Status Event Status Register to be set when all

previously started local overlapped commands are complete.

Note that each node independently sets its operation complete bits in its own status model. Any

nodes that are not actively performing overlapped commands set their bits immediately. All remaining

nodes set their own bits as they complete their own overlapped commands.

Example

opc()

waitcomplete()

print("1")

Output:

Also see

*OPC (on page A-6)

Status model (on page B-1)

waitcomplete() (on page 14-292)

Tektronix Keithley SourceMeter 2470 Reference Manual

Other manuals for Tektronix Keithley SourceMeter 2470