Tektronix Keithley SourceMeter 2470 Reference Manual

2470
High Voltage SourceMeter Instrument Reference Manual Section 12:
SCPI command reference
2470-901-01 Rev. A / May 2019 12-43
Example 2
RES:AVER:COUNT 10
RES:AVER:TCON MOV
RES:AVER ON
For resistance measurements, set the averaging filter type to
moving average, with a filter count of 10.
Enable the averaging filter.
Example 3
VOLT:AVER:COUNT 10
VOLT:AVER:TCON MOV
VOLT:AVER ON
For voltage measurements, set the averaging filter type to
moving average, with a filter count of 10.
Enable the averaging filter.
Also see
Filtering measurement data (on page 5-25)
[:SENSe[1]]:<function>:AVERage[:STATe] (on page 12-43)
[:SENSe[1]]:<function>:AVERage:TCONtrol (on page 12-44)
[:SENSe[1]]:<function>:AVERage[:STATe]
This command enables or disables the averaging filter for measurements of the selected function.
Type Affected by Where saved Default value
Command and query
Recall settings
Instrument reset
Power cycle
Measure configuration list
Save settings
Measure configuration list
OFF (0)
Usage
[:SENSe[1]]:<function>:AVERage[:STATe] <state>
[:SENSe[1]]:<function>:AVERage[:STATe]?
<function>
The measure function:
 Current: CURRent[:DC]
 Resistance: RESistance
 Voltage:
VOLTage[:DC]
<state>
The filter status; set to one of the following values:
 Disable the averaging filter: OFF or 0
 Enable the averaging filter:
ON
or
1
Details
This command enables or disables the averaging filter. When this is enabled, the reading returned by
the instrument is an averaged value, taken from multiple measurements. The settings of the filter
count and filter type for the selected measure function determines how the reading is averaged.
If you send this command without the <function> parameter, it sets the state of the averaging filter
for all functions.

Tektronix Keithley SourceMeter 2470 Specifications

General

Brand	Tektronix
Model	Keithley SourceMeter 2470
Category	Measuring Instruments
Language	English