Tektronix Keithley SourceMeter 2470 Reference Manual

2470
High Voltage SourceMeter Instrument Reference Manual Section 12:
SCPI command reference
2470-901-01 Rev. A / May 2019 12-65
[:SENSe[1]]:CONFiguration:LIST:STORe
This command stores the active measure settings into the named configuration list.
Type Affected by Where saved Default value
Command only
Recall settings
Instrument reset
Power cycle
Saved settings
Not applicable
Usage
[:SENSe[1]]:CONFiguration:LIST:STORe "<name>"
[:SENSe[1]]:CONFiguration:LIST:STORe "<name>", <index>
<name>
A string that represents the name of a measure configuration list
<index>
A number that defines a specific configuration index in the configuration list
Details
Use this command to store the active measure settings to a configuration index in a configuration list.
If the index parameter is not provided, the new settings are appended to the end of the list. The index
only stores the active settings for a single active measure function.
Configuration lists are not saved when the instrument is turned off or reset. To save a configuration
list, create a configuration script to save instrument settings, including any defined configuration lists.
Refer to Instrument settings stored in a measure configuration list (on page 4-86
) for a complete list of
measure settings that the instrument stores.
Example
:SENSe:CONF:LIST:STOR "MyConfigList"
Stores the active settings of the instrument to
the end of the configuration list named
MyConfigList.
:SENSe:CONF:LIST:STOR "MyConfigList", 5
Stores the active settings of the instrument to
the configuration list named MyConfigList
in configuration index 5.
Also see
Configuration lists (on page 4-83)
[:SENSe[1]]:CONFiguration:LIST:CREate (on page 12-61)
*SAV (on page 12-9)

Tektronix Keithley SourceMeter 2470 Specifications

General

Brand	Tektronix
Model	Keithley SourceMeter 2470
Category	Measuring Instruments
Language	English