High Voltage SourceMeter Instrument Reference Manual Section 13:
Introduction to TSP commands
2470-901-01 Rev. A / May 2019 13-53
TSP-Link
TSP-link commands allow you to control and access the TSP-Link synchronization port. Use these
commands to perform basic steady-state digital I/O operations; for example, you can program the
instrument to read and write to a specific TSP-Link synchronization line or to the entire port.
trigger.tsplinkin[N].edge (on page 14-262)
trigger.tsplinkin[N].overrun (on page 14-263)
trigger.tsplinkin[N].wait() (on page 14-264)
trigger.tsplinkout[N].assert() (on page 14-264)
trigger.tsplinkout[N].logic (on page 14-265)
trigger.tsplinkout[N].pulsewidth (on page 14-266)
trigger.tsplinkout[N].release() (on page 14-266)
trigger.tsplinkout[N].stimulus (on page 14-267)
tsplink.group (on page 14-269)
tsplink.initialize() (on page 14-270)
tsplink.line[N].mode (on page 14-271)
tsplink.line[N].reset() (on page 14-272)
tsplink.line[N].state (on page 14-273)
tsplink.master (on page 14-273)
tsplink.node (on page 14-274)
tsplink.readport() (on page 14-274)
tsplink.state (on page 14-275)
tsplink.writeport() (on page 14-276)
TSP-net
TSP-Net provides a simple socket-like programming interface to Test Script Processor (TSP) enabled
instruments.
tspnet.clear() (on page 14-276)
tspnet.connect() (on page 14-277)
tspnet.disconnect() (on page 14-278)
tspnet.execute() (on page 14-279)
tspnet.idn() (on page 14-280)
tspnet.read() (on page 14-281)
tspnet.readavailable() (on page 14-282)
tspnet.reset() (on page 14-283)
tspnet.termination() (on page 14-283)
tspnet.timeout (on page 14-284)
tspnet.tsp.abort() (on page 14-285)
tspnet.tsp.abortonconnect (on page 14-285)
tspnet.tsp.rbtablecopy() (on page 14-286)
tspnet.tsp.runscript() (on page 14-287)
tspnet.write() (on page 14-287)
To Next Page
Loading...
Need help?
General
