A: Common commands 2470 High Voltage SourceMeter Instrument
A-10 2470-901-01 Rev. A / May 2019
*TST?
This command is accepted and returns 0. A self-test is not actually performed.
Type Affected by Where saved Default value
Usage
*TST?
Also see
None
*WAI
This command postpones the execution of subsequent commands until all previous overlapped commands are
finished.
Type Affected by Where saved Default value
Usage
*WAI
Details
There are two types of instrument commands:
• Overlapped commands: Commands that allow the execution of subsequent commands while
i
nstrument operations of the overlapped command are still in progress.
• Sequential commands: Commands whose operations must finish before the next command is
executed.
The *WAI command suspends the execution of commands until the instrument operations of all
previous overlapped commands are finished. The *WAI command is not needed for sequential
commands. Typically, this command is sent after the initiate trigger model command.
Also see
:INITiate[:IMMediate] (on page 12-143)
waitcomplete() (on page 14-292)
To Next Page
Loading...
Need help?
General
