13: Introduction to TSP commands 2470 High Voltage SourceMeter Instrument
13-46 2470-901-01 Rev. A / May 2019
Reading buffer
Reading buffers capture measurements, ranges, instrument status, and output states of the
instrument.
buffer.clearstats() (on page 14-8)
buffer.delete() (on page 14-9)
buffer.getstats() (on page 14-10)
buffer.make() (on page 14-12)
buffer.save() (on page 14-14)
buffer.saveappend() (on page 14-15)
bufferVar.capacity (on page 14-17)
bufferVar.clear() (on page 14-18)
bufferVar.dates (on page 14-20)
bufferVar.endindex (on page 14-21)
bufferVar.fillmode (on page 14-23)
bufferVar.formattedreadings (on page 14-24)
bufferVar.fractionalseconds (on page 14-25)
bufferVar.logstate (on page 14-26)
bufferVar.n (on page 14-26)
bufferVar.readings (on page 14-28)
bufferVar.relativetimestamps (on page 14-29)
bufferVar.seconds (on page 14-30)
bufferVar.sourceformattedvalues (on page 14-31)
bufferVar.sourcestatuses (on page 14-32)
bufferVar.sourceunits (on page 14-33)
bufferVar.sourcevalues (on page 14-35)
bufferVar.startindex (on page 14-36)
bufferVar.statuses (on page 14-37)
bufferVar.times (on page 14-38)
bufferVar.timestamps (on page 14-39)
bufferVar.units (on page 14-41)
buffer.write.format() (on page 14-42)
buffer.write.reading() (on page 14-44)
printbuffer() (on page 14-100)
Reset
Resets settings to their default settings.
digio.line[N].reset() (on page 14-53)
reset() (on page 14-104)
smu.reset() (on page 14-150)
timer.cleartime() (on page 14-192)
trigger.blender[N].reset() (on page 14-194)
trigger.timer[N].reset() (on page 14-256)
tsplink.line[N].reset() (on page 14-272)
tspnet.reset() (on page 14-283)
To Next Page
Loading...
