High Voltage SourceMeter Instrument Reference Manual Section 14:
2470-901-01 Rev. A / May 2019 14-181
status.operation.condition
This attribute reads the Operation Event Register of the status model.
Type TSP-Link accessible Affected by Where saved Default value
Usage
operationRegister = status.operation.condition
The status of the operation status register; a zero (0) indicates no
bits set; other values indicate various bit settings
Details
This command reads the contents of the Operation Condition Register, which is one of the Operation
Event Registers.
For detail on interpreting the value of a register, see Understanding bit settings (on page B-15
).
Example
print(status.operation.condition)
Returns the contents of the register.
Also see
Operation Event Register (on page B-7)
status.operation.enable
This attribute sets or reads the contents of the Operation Event Enable Register of the status model.
Type TSP-Link accessible Affected by Where saved Default value
Attribute (RW) Yes status.preset() Not applicable 0
Usage
operationRegister = status.operation.enable
status.operation.enable = operationRegister
The status of the operation status register
Details
This command sets or reads the contents of the Enable register of the Operation Event Register.
When one of these bits is set, when the corresponding bit in the Operation Event Register or
Operation Condition Register is set, the OSB bit in the Status Byte Register is set.
To Next Page
Loading...
Need help?
General
