Tektronix Keithley SourceMeter 2470 Reference Manual

2470
High Voltage SourceMeter Instrument Reference Manual Section 12:
SCPI command reference
2470-901-01 Rev. A / May 2019 12-143
:INITiate[:IMMediate]
This command starts the trigger model.
Type Affected by Where saved Default value
Command only
Not applicable
Not applicable
Not applicable
Usage
:INITiate[:IMMediate]
Example
INIT
*WAI
Starts the trigger model and then waits until the commands are complete to accept new commands.
Also see
:ABORt (on page 12-142)
Trigger model (on page 8-27)
:TRIGger:BLENder<n>:CLEar
This command clears the blender event detector and resets the overrun indicator of blender <n>.
Type Affected by Where saved Default value
Command only
Not applicable
Not applicable
Not applicable
Usage
:TRIGger:BLENder<n>:CLEar
<n>
The blender number (up to two)
Details
This command sets the blender event detector to the undetected state and resets the overrun
indicator of the event detector.
Example
:TRIG:BLEN2:CLE
Clears the event detector for blender 2.
Also see
None

Tektronix Keithley SourceMeter 2470 Specifications

General

Brand	Tektronix
Model	Keithley SourceMeter 2470
Category	Measuring Instruments
Language	English