Tektronix Keithley SourceMeter 2470 Reference Manual

2470
High Voltage SourceMeter Instrument Reference Manual Section 12:
SCPI command reference
2470-901-01 Rev. A / May 2019 12-177
:TRIGger:LAN<n>:IN:OVERrun?
This command indicates the overrun status of the LAN event detector.
Type Affected by Where saved Default value
Query only
LAN trigger clear
Not applicable
Not applicable
Usage
:TRIGger:LAN<n>:IN:OVERrun?
<n>
The LAN event number (1 to 8)
Details
This command indicates whether an event has been ignored because the event detector was already
in the detected state when the event occurred.
This is an indication of the state of the event detector built into the synchronization line itself. It does
not indicate if an overrun occurred in any other part of the trigger model, or in any other construct that
is monitoring the event.
It also is not an indication of an output trigger overrun.
The trigger overrun state for the specified LAN packet is returned as 1 (true) or 0 (false).
Example
TRIG:LAN5:IN:OVER?
Checks the overrun status of a trigger on LAN5 and outputs the
value, such as:
0
Also see
:TRIGger:LAN<n>:IN:CLEar (on page 12-175)
:TRIGger:LAN<n>:OUT:CONNect:STATe
This command prepares the event generator for outgoing trigger events.
Type Affected by Where saved Default value
Command and query
Not applicable
Not applicable
Not applicable
Usage
:TRIGger:LAN<n>:OUT:CONNect:STATe <state>
:TRIGger:LAN<n>:OUT:CONNect:STATe?
<n>
The LAN event number (1 to 8)
<state>
Do not send event messages:
OFF
or
0
Prepare to send event messages:
ON
or
1

Tektronix Keithley SourceMeter 2470 Specifications

General

Brand	Tektronix
Model	Keithley SourceMeter 2470
Category	Measuring Instruments
Language	English