High Voltage SourceMeter Instrument Reference Manual Section 13:
Introduction to TSP commands
2470-901-01 Rev. A / May 2019 13-45
LAN
LAN commands provide options that allow you to review and configure network settings over the
remote interface.
The following commands contain the status of the LAN.
lan.ipconfig() (on page 14-86)
lan.lxidomain (on page 14-87)
lan.macaddress (on page 14-87)
Set up and assert trigger events that are sent over the LAN.
trigger.lanin[N].clear() (on page 14-206)
trigger.lanin[N].edge (on page 14-206)
trigger.lanin[N].overrun (on page 14-207)
trigger.lanin[N].wait() (on page 14-208)
trigger.lanout[N].assert() (on page 14-208)
trigger.lanout[N].connect() (on page 14-209)
trigger.lanout[N].connected (on page 14-210)
trigger.lanout[N].disconnect() (on page 14-211)
trigger.lanout[N].ipaddress (on page 14-211)
trigger.lanout[N].logic (on page 14-212)
trigger.lanout[N].protocol (on page 14-212)
trigger.lanout[N].stimulus (on page 14-213)
GPIB
These commands store the GPIB address and indicate whether GPIB communication is enabled.
gpib.address (on page 14-85
)
To Next Page
Loading...
Need help?
General
