Tektronix Keithley SourceMeter 2470 - Buffervar.times

Section
14: TSP command reference 2470 High Voltage SourceMeter Instrument
Reference Manual
14-38 2470-901-01 Rev. A / May 2019
Example
reset()
testData = buffer.make(50)
smu.source.output = smu.ON
trigger.model.load("SimpleLoop", 2, 0, testData)
trigger.model.initiate()
waitcomplete()
printbuffer(1, 2, testData.statuses)
Create a reading buffer named testData,
configure the instrument to make two
measurements, and store the readings in
the buffer.
Turn on the source output.
Print the source status for the readings in
testData.
Output:
64, 64
Indicating that the status is
buffer.STAT_LIMIT1_LOW
.
Also see
buffer.make() (on page 14-12)
buffer.delete() (on page 14-9)
bufferVar.clear() (on page 14-18)
bufferVar.sourcestatuses (on page 14-32)
print() (on page 14-99)
printbuffer() (on page 14-100)
Reading buffers (on page 6-1)
Remote buffer operation (on page 6-25)
bufferVar.times
This attribute contains the time when the instrument made the reading.
Type TSP-Link accessible Affected by Where saved Default value
Attribute (R)
Yes
Restore configuration
Instrument reset
Power cycle
Not applicable
Not applicable
Usage
readingTime = bufferVar.times[N]
readingTime
The time of the reading in hours, minutes, and seconds
bufferVar
The name of the reading buffer, which may be a default buffer (
defbuffer1
or
defbuffer2
) or a user-defined buffer
N
The reading number
N
; can be any value from 1 to the number of readings in the
buffer; use the bufferVar.n command to determine the number of readings in the
buffer