Tektronix Keithley SourceMeter 2470

Section
14: TSP command reference 2470 High Voltage SourceMeter Instrument
Reference Manual
14-272 2470-901-01 Rev. A / May 2019
tsplink.line[N].reset()
This function resets some of the TSP-Link trigger attributes to their factory defaults.
Type TSP-Link accessible
Affected by Where saved Default value
Function
Yes
Usage
tsplink.line[N].reset()
N
The trigger line (1 to 3)
Details
The tsplink.line[N].reset() function resets the following attributes to their default values:
• tsplink.line[N].mode
• trigger.tsplinkin[N].edge
• trigger.tsplinkout[N].logic
• trigger.tsplinkout[N].pulsewidth
• trigger.tsplinkout[N].stimulus
This also clears trigger.tsplinkin[N].overrun.
Example
tsplink.line[3].reset()
Resets TSP-Link trigger line 3 attributes to
default values.
Also see
trigger.tsplinkin[N].edge (on page 14-262)
trigger.tsplinkin[N].overrun (on page 14-263)
trigger.tsplinkout[N].logic (on page 14-265)
trigger.tsplinkout[N].pulsewidth (on page 14-266)
trigger.tsplinkout[N].stimulus (on page 14-267)
tsplink.line[N].mode (on page 14-271)