9: TSP-Link and TSP-Net 2470 High Voltage SourceMeter Instrument
9-16 2470-901-01 Rev. A / May 2019
Remote instrument events
If the 2470 is connected to a TSP-enabled instrument through TSP-Net, all events that occur on the
remote instrument are transferred to the event log of the 2470. The 2470 indicates events from the
remote instrument by prefacing these events with “Remote Error.” For example, if the remote
instrument generates event code 4909, "Reading buffer not found within device," the 2470 generates
the string “Remote Error: (4909) Reading buffer not found within device.”
TSP-Net instrument commands: General device control
The following instrument commands provide general device control:
tspnet.clear() (on page 14-276)
tspnet.connect() (on page 14-277)
tspnet.disconnect() (on page 14-278)
tspnet.execute() (on page 14-279)
tspnet.idn() (on page 14-280)
tspnet.read() (on page 14-281)
tspnet.readavailable() (on page 14-282)
tspnet.reset() (on page 14-283)
tspnet.termination() (on page 14-283)
tspnet.timeout (on page 14-284)
tspnet.write() (on page 14-287)
TSP-Net instrument commands: TSP-enabled device control
The following instrument commands provide TSP-enabled device control:
tspnet.tsp.abort() (on page 14-285)
tspnet.tsp.abortonconnect (on page 14-285)
tspnet.tsp.rbtablecopy() (on page 14-286)
tspnet.tsp.runscript() (on page 14-287)
To Next Page
Loading...
Need help?
General
