14: TSP command reference 2470 High Voltage SourceMeter Instrument
14-116 2470-901-01 Rev. A / May 2019
smu.measure.configlist.delete()
This function deletes a measure configuration list.
Type TSP-Link accessible
Affected by Where saved Default value
Usage
smu.measure.configlist.delete("listName")
smu.measure.configlist.delete("listName", index)
A string that represents the name of a measure configuration list
A number that defines a specific configuration index in the configuration list
Details
Deletes a configuration list. If the index is not specified, the entire configuration list is deleted. If the
index is specified, only the specified configuration index in the list is deleted.
When an index is deleted from a configuration list, the index numbers of the following indexes are
shifted up by one. For example, if you have a configuration list with 10 indexes and you delete index
3, the index that was numbered 4 becomes index 3, and the all the following indexes are renumbered
in sequence to index 9. Because of this, if you want to delete several nonconsecutive indexes in a
configuration list, it is best to delete the higher numbered index first, then the next lower index, and so
on. This also means that if you want to delete all the indexes in a configuration list, you must delete
index 1 repeatedly until all indexes have been removed.
Example
smu.measure.configlist.delete("myMeasList")
Delete a measure configuration list named
myMeasList
.
smu.measure.configlist.delete("myMeasList", 2)
Delete configuration index 2 from the
measure configuration list named
Also see
Configuration lists (on page 4-83)
createconfigscript() (on page 14-46)
smu.measure.configlist.create() (on page 14-115)
To Next Page
Loading...
Need help?
General
