High Voltage SourceMeter Instrument Reference Manual Section 13:
Introduction to TSP commands
2470-901-01 Rev. A / May 2019 13-49
smu.measure.sense (on page 14-147)
smu.terminals (on page 14-178)
smu.measure.unit (on page 14-148)
smu.measure.userdelay[N] (on page 14-149)
SMU source commands are:
smu.source.autorange (on page 14-151)
smu.source.autodelay (on page 14-152)
smu.source.configlist.catalog() (on page 14-152)
smu.source.configlist.create() (on page 14-153)
smu.source.configlist.delete() (on page 14-154)
smu.source.configlist.query() (on page 14-155)
smu.source.configlist.recall() (on page 14-156)
smu.source.configlist.size() (on page 14-157)
smu.source.configlist.store() (on page 14-158)
smu.source.delay (on page 14-159)
smu.source.func (on page 14-160)
smu.source.highc (on page 14-160)
smu.source.level (on page 14-161)
smu.source.offmode (on page 14-162)
smu.source.output (on page 14-164)
smu.source.protect.level (on page 14-164)
smu.source.protect.tripped (on page 14-165)
smu.source.range (on page 14-166)
smu.source.readback (on page 14-167)
smu.source.sweeplinear() (on page 14-168)
smu.source.sweeplinearstep() (on page 14-170)
smu.source.sweeplist() (on page 14-172)
smu.source.sweeplog() (on page 14-174)
smu.source.userdelay[N] (on page 14-176)
smu.source.xlimit.level (on page 14-177)
smu.source.xlimit.tripped (on page 14-178)
To Next Page
Loading...
Need help?
General
