Tektronix Keithley SourceMeter 2470

Section
8: Triggering 2470 High Voltage SourceMeter Instrument Reference
Manual
8-8 2470-901-01 Rev. A / May 2019
Some attributes of trigger timers should not be used with the trigger model. Attributes you should not
set are:
 Count value of 0 (resulting in generation of trigger events indefinitely)
 Delay lists
Remote trigger timer commands
SCPI trigger timer commands:
• :TRIGger:TIMer<n>:CLEar (on page 12-192)
• :TRIGger:TIMer<n>:COUNt (on page 12-192)
• :TRIGger:TIMer<n>:DELay (on page 12-194)
• :TRIGger:TIMer<n>:STARt:FRACtional (on page 12-194)
• :TRIGger:TIMer<n>:STARt:GENerate (on page 12-195)
• :TRIGger:TIMer<n>:STARt:OVERrun? (on page 12-195)
• :TRIGger:TIMer<n>:STARt:SEConds (on page 12-196)
• :TRIGger:TIMer<n>:STARt:STIMulus (on page 12-197)
• :TRIGger:TIMer<n>:STATe (on page 12-198)
TSP trigger timer commands:
• trigger.timer[N].clear() (on page 14-251)
• trigger.timer[N].count (on page 14-252)
• trigger.timer[N].delay (on page 14-253)
• trigger.timer[N].delaylist (on page 14-254)
• trigger.timer[N].enable (on page 14-255)
• trigger.timer[N].reset() (on page 14-256)
• trigger.timer[N].start.fractionalseconds (on page 14-257)
• trigger.timer[N].start.generate (on page 14-257)
• trigger.timer[N].start.overrun (on page 14-258)
• trigger.timer[N].start.seconds (on page 14-259)
• trigger.timer[N].start.stimulus (on page 14-259)
• trigger.timer[N].wait() (on page 14-261)