PKT-INT (Packet Interface)
Issue 4 May 2002
10-1319555-233-123
1 FAIL Peer link setup between the active and standby Packet
Interfaces failed.
1. Use the display alarms command to display the active
alarms. If there are any errors associated with the Packet
Bus, refer to the PKT-BUS maintenance documentation to
clear the Packet Bus problems first.
2. Retry the test command after a one minute delay.
3. If the test continues to fail, replace the TN2401/TN794
NetPkt circuit pack on the standby SPE.
4. If the test continues to fail:
a. Use the display alarms command to display the active
alarms. Verify that there are no alarms on the standby
SPE components other than the PKT-INT alarms for the
Peer Link failure. If there are other alarms for SPE
components, clear those alarms first.
b. Initiate an SPE interchange by moving the SPE
SELECT switches on the DUPINT circuit packs to the
position corresponding to the carrier location of the
standby SPE. This causes an SPE interchange using a
WARM restart, assuming refresh is complete.
Established calls are not disconnected.
c. Replace the TN2401/TN794 NetPkt circuit pack on the
standby SPE and restore the SPE SELECT switches to
their neutral position.
Table 10-488. TEST #888 Active-Standby Peer Link Test — Continued
Error
Code
Tes t
Result Description/Recommendation
Continued on next page
To Next Page
Loading...
