ANL-LINE (8-Port Analog Line), ANL-NE-L (8-Port Neon
Analog Line)
Issue 4 May 2002
10-87 555-233-123
Hardware Error Log Entries and Test to Clear
Val ues
Notes:
a. These are in-line errors and can only be resolved over time.
■ 40960—indicates that too many simultaneous incoming ringing
attempts were made on this board. Only four ports on a board may
be ringing simultaneously. A fifth incoming call will cause an inline
error from the board.
■ 40975—indicates that the terminal equipment was on-hook when
ring-tip was detected during ringing. This usually indicates a failure
in the terminal equipment or the type of terminal has a low ringer
impedance. Call the terminal equipment and verify that the terminal
Table 10-31. 8-Port Analog Line Error Log Entries
Error
Type
Aux
Data Associated Test
Alarm
Level
On/Off
Board Test to Clear Value
0
1
1 Run the Short Test Sequence first. If all tests pass, run the Long Test Sequence. Refer to the
appropriate test description and follow the recommended procedures.
0 Any Any Any test port PCSSpp sh r 1
1 (a) 40960
40975
40977
None
15 (b) Any Audits and Updates
Test (#36)
18 0 busyout station
<extension>
WRN OFF release station <extension>
130(c) None WRN ON test port PCSSpp sh
257 (d) Station Present Test
(#48)
WRN OFF test port PCSSpp sh r 3
513 Battery Feed Test
(#35)
MIN/
WRN
2
2 Major or Minor alarms on this MO may be downgraded to Warning alarms based on the values used
in the set options command.
ON test port PCSSpp sh r 2
769 (e) Loop Around and
Conference Test(#47)
test port PCSSpp l r 3
1025 NPE Crosstalk Test
(#6)
MIN/
WRN
2
ON test port PCSSpp l r 3
1281 (f)
1793 (f)
To Next Page
Loading...
