Cisco MDS 9000 Series Command Reference

Send documentation comments to mdsfeedback-doc@cisco.com
22-49
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 22 Show Commands
show crypto transform-set domain ipsec
show crypto transform-set domain ipsec
To display transform set information for IPsec, use the show crypto transform-set domain ipsec
command.
show crypto transform-set domain ipsec [set-name]
Syntax Description
Defaults Displays information for all transform sets.
Command Modes EXEC mode.
Command History
Usage Guidelines To use this command, IPsec must be enabled using the crypto ipsec enable command.
Examples The following example shows how to display information for all IPsec transform sets.
switch# show crypto transform-set domain ipsec
Transform set: ipsec_default_transform_set {esp-aes-256-ctr esp-aes-xcbc-mac}
will negotiate {tunnel}
Related Commands
set-name Specifies the transform set name. Maximum length is 63 characters.
Release Modification
2.0(x) This command was introduced.
Command Description
crypto ipsec enable Enables IPsec.
crypto transform-set
domain ipsec
Configures IPsec transform set information.

Cisco MDS 9000 Series Specifications

General

Category	Switch
Operating System	Cisco NX-OS
Ports	Varies by model
Protocols	Fibre Channel (FC), Fibre Channel over IP (FCIP), iSCSI
Redundancy	Redundant supervisors, power supplies, and fans
Management	Cisco Data Center Network Manager (DCNM), CLI, SNMP
Virtualization Support	VSANs (Virtual SANs)
Security Features	Fibre Channel Security Protocol (FC-SP)
Hot Swappable Components	power supplies, fans
Power Supply Options	AC and DC options available