EasyManuals Logo

Cisco MDS 9000 Series Command Reference

Cisco MDS 9000 Series
1464 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #1160 background imageLoading...
Page #1160 background image
Send documentation comments to mdsfeedback-doc@cisco.com
22-186
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 22 Show Commands
show islb virtual-target
show islb virtual-target
To display information about iSLB virtual targets, use the show islb virtual-target command.
show islb virtual-target [name | configured name]
Syntax Description
Defaults None.
Command Modes EXEC mode.
Command History
Usage Guidelines None.
Examples The following example shows an iSLB target.
switch# show islb virtual-target newtarget0987654321
target: newtarget0987654321
Configured node (iSLB)
No. of initiators permitted: 1
initiator fromtarget1234567890 is permitted
All initiator permit is enabled
Trespass support is disabled
Revert to primary support is disabled
The following example shows all configured iSLB virtual targets.
switch# show islb virtual-target configured
target: testtarget1234567
Configured node (iSLB)
No. of initiators permitted: 1
initiator trespass is permitted
All initiator permit is disabled
Trespass support is disabled
Revert to primary support is disabled
target: testertarget987654321
Port WWN 10:20:30:40:50:60:70:80
Configured node (iSLB)
No. of initiators permitted: 1
initiator mytargetdevice is permitted
All initiator permit is disabled
name Specifies the iSLB virtual target name. The range is 16 bytes to 223 bytes.
configured Displays information about configured iSLB virtual targets.
Release Modification
3.0(1) This command was introduced.

Table of Contents

Other manuals for Cisco MDS 9000 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco MDS 9000 Series and is the answer not in the manual?

Cisco MDS 9000 Series Specifications

General IconGeneral
CategorySwitch
Operating SystemCisco NX-OS
PortsVaries by model
ProtocolsFibre Channel (FC), Fibre Channel over IP (FCIP), iSCSI
RedundancyRedundant supervisors, power supplies, and fans
ManagementCisco Data Center Network Manager (DCNM), CLI, SNMP
Virtualization SupportVSANs (Virtual SANs)
Security FeaturesFibre Channel Security Protocol (FC-SP)
Hot Swappable Componentspower supplies, fans
Power Supply OptionsAC and DC options available

Related product manuals