Send documentation comments to mdsfeedback-doc@cisco.com
22-274
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 22 Show Commands
show rlir
show rlir
To display the information about Registered Link Incident Report (RLIR), Link Incident Record
Registration (LIRR), and Distribute Registered Link Incident Record (DRLIR) frames, use the show rlir
command.
show rlir {erl [vsan vsan-id] | history | recent [interface fc slot/port | portnumber port-number]
| statistics [vsan vsan-id]}
Note On a Cisco Fabric Switch for HP c-Class BladeSystem and on a Cisco Fabric Switch for IBM
BladeCenter, the syntax differs as follows:
interface {bay port | ext port}
Syntax Description
Defaults None.
Command Modes EXEC mode.
Command History
Usage Guidelines If available, the host timestamp (marked by the *) is printed along with the switch timestamp. If the host
timestamp is not available, only the switch timestamp is printed.
erl vsan-id Displays Established Registration List (ERL) information.
vsan vsan-id Specifies a VSAN ID. The range is 1 to 4093.
history Displays link incident history.
recent Displays recent link incident.
interface Specifies an interface.
fc slot/port (Optional) Specifies a Fibre Channel interface on a Cisco MDS 9000
Family Switch.
bay port | ext port} (Optional) Specifies a Fibre Channel interface on a Cisco MDS 9124
Fabric Switch, a Cisco Fabric Switch for HP c-Class BladeSystem, and a
Cisco Fabric Switch for IBM BladeCenter.
portnumber port-number Specifies a port number for the link incidents. The range is 1 to 224.
statistics Displays RLIR statistics.
Release Modification
1.3(2) This command was introduced.
3.0(3) Modified the show rlir erl command.
3.1(2) Added the bay port | ext port keywords and arguments.
To Next Page
Loading...
Need help?
General
