Cisco MDS 9000 Series Command Reference

Send documentation comments to mdsfeedback-doc@cisco.com
18-24
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 18 P Commands
port-security enable
port-security enable
To enable port security, use the port-security enable command in configuration mode. To disable port
security, use the no form of the command.
port-security enable
no port-security enable
Syntax Description This command has no other arguments or keywords.
Defaults Disabled.
Command Modes Configuration mode.
Command History
Usage Guidelines Issuing the port-security enable command enables the other commands used to configure port security.
Examples The following example shows how to enable port security.
switch# config terminal
switch(config)# port-security enable
The following example shows how to disable port security.
switch# config terminal
switch(config)# no port-security enable
Related Commands
Release Modification
2.0(x) This command was introduced.
Command Description
show port-security Displays port security information.

Cisco MDS 9000 Series Specifications

General

Category	Switch
Operating System	Cisco NX-OS
Ports	Varies by model
Protocols	Fibre Channel (FC), Fibre Channel over IP (FCIP), iSCSI
Redundancy	Redundant supervisors, power supplies, and fans
Management	Cisco Data Center Network Manager (DCNM), CLI, SNMP
Virtualization Support	VSANs (Virtual SANs)
Security Features	Fibre Channel Security Protocol (FC-SP)
Hot Swappable Components	power supplies, fans
Power Supply Options	AC and DC options available