Cisco MDS 9000 Series Command Reference

Send documentation comments to mdsfeedback-doc@cisco.com
11-115
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 11 I Commands
isns profile name
isns profile name
To create an Internet Storage Name Service (iSNS) profile and enter iSNS profile configuration
submode, use the isns profile name command in configuration mode. To delete the iSNS profile, use the
no form of the command.
isns profile name profile-name
no isns profile name profile-name
Syntax Description
Defaults None.
Command Modes Configuration mode.
Command History
Usage Guidelines To use this command, iSNS must be enabled using the isns-server enable command.
Examples The following example shows how to specify an iSNS profile name and enter iSNS profile configuration
submode.
switch# config terminal
switch(config)# isns profile name UserProfile
switch(config-isns-profile)#
Related Commands
profile-name Specifies the profile name. Maximum length is 64 characters.
Release Modification
1.3(1) This command was introduced.
Command Description
server Configures a server IP address in an iSNS profile.
show isns Displays iSNS information.

Cisco MDS 9000 Series Specifications

General

Category	Switch
Operating System	Cisco NX-OS
Ports	Varies by model
Protocols	Fibre Channel (FC), Fibre Channel over IP (FCIP), iSCSI
Redundancy	Redundant supervisors, power supplies, and fans
Management	Cisco Data Center Network Manager (DCNM), CLI, SNMP
Virtualization Support	VSANs (Virtual SANs)
Security Features	Fibre Channel Security Protocol (FC-SP)
Hot Swappable Components	power supplies, fans
Power Supply Options	AC and DC options available