Cisco MDS 9000 Series Command Reference

Send documentation comments to mdsfeedback-doc@cisco.com
4-93
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 4 C Commands
cloud discover
cloud discover
To initiate manual, on-demand cloud discovery, use the cloud discover command.
cloud discover [interface {gigabitethernet slot/port | port-channel port-channel-number}]
Syntax Description
Defaults None.
Command Modes EXEC mode.
Command History
Usage Guidelines This command is not supported on the Cisco MDS 9124 switch, the Cisco Fabric Switch for HP c-Class
BladeSystem, and the Cisco Fabric Switch for IBM BladeCenter.
Examples The following example initiates manual, on-demand cloud discovery.
switch# cloud discover
The following example initiates manual, on-demand cloud discovery on Gigabit Ethernet interface 2/2.
switch# cloud discover interface gigabitethernet 2/2
Related Commands
interface Specifies an interface for cloud discovery.
gigabitethernet
slot/port
Specifies a Gigabit Ethernet interface.
port-channel
port-channel-number
Specifies a PortChannel interface. The range for the PortChannel number is
1 to 256.
Release Modification
3.0(1) This command was introduced.
Command Description
cloud discovery Configures cloud discovery.
cloud-discovery enable Enables discovery of cloud memberships.
show cloud discovery Displays discovery information about the cloud.
show cloud membership Displays information about members of the cloud.

Cisco MDS 9000 Series Specifications

General

Category	Switch
Operating System	Cisco NX-OS
Ports	Varies by model
Protocols	Fibre Channel (FC), Fibre Channel over IP (FCIP), iSCSI
Redundancy	Redundant supervisors, power supplies, and fans
Management	Cisco Data Center Network Manager (DCNM), CLI, SNMP
Virtualization Support	VSANs (Virtual SANs)
Security Features	Fibre Channel Security Protocol (FC-SP)
Hot Swappable Components	power supplies, fans
Power Supply Options	AC and DC options available