Cisco MDS 9000 Series Command Reference

Send documentation comments to mdsfeedback-doc@cisco.com
4-79
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 4 C Commands
clear system reset-reason
clear system reset-reason
To clear the reset-reason information stored in NVRAM and volatile persistent storage, use the clear
system reset-reason command in EXEC mode.
clear system reset-reason
Syntax Description This command has no arguments or keywords.
Defaults None.
Command Modes EXEC mode.
Command History
Usage Guidelines Use this command as listed below:
• In a Cisco MDS 9500 Series switch, this command clears the reset-reason information stored in
NVRAM and volatile persistent storage in the active and standby supervisor modules.
• In a Cisco MDS 9200 Series switch, this command clears the reset-reason information stored in
NVRAM and volatile persistent storage in the active supervisor module.
Examples The following example shows how to clear trusted SSH hosts.
switch# clear system reset-reason
Related Commands
Release Modification
1.3(2a) This command was introduced.
Command Description
show system reset-reason Displays system reset-reason information.

Cisco MDS 9000 Series Specifications

General

Category	Switch
Operating System	Cisco NX-OS
Ports	Varies by model
Protocols	Fibre Channel (FC), Fibre Channel over IP (FCIP), iSCSI
Redundancy	Redundant supervisors, power supplies, and fans
Management	Cisco Data Center Network Manager (DCNM), CLI, SNMP
Virtualization Support	VSANs (Virtual SANs)
Security Features	Fibre Channel Security Protocol (FC-SP)
Hot Swappable Components	power supplies, fans
Power Supply Options	AC and DC options available