Cisco MDS 9000 Series Command Reference

Send documentation comments to mdsfeedback-doc@cisco.com
6-121
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 6 Debug Commands
debug tlport
debug tlport
To enable debugging for TL port interfaces, use the debug tlport command in EXEC mode. To disable
a debug command, use the no form of the command or use the no debug all command to turn off all
debugging.
debug tlport {all | errors | events {fc2 {terminal | transit} | mts | pss}} [interface fc slot/port]
no debug tlport {all | errors | events {fc2 {terminal | transit} | mts | pss}} [interface fc slot/port]
Syntax Description
Defaults Disabled.
Command Modes EXEC mode.
Command History
Usage Guidelines None.
Examples The following example displays the system output when the debug tlport events pss command is issued:
switch# debug tlport events pss
Related Commands
all Enables debugging for all TL port features.
errors Enables debugging for TL port error conditions.
events Enables debugging for TL port monitoring events.
fc2 Enables debugging for TL port monitoring FC 2 events.
terminal Specifies TL port monitoring FC 2 terminating events.
transit Specifies TL port monitoring FC 2 transit events.
mts Enables debugging for TL port monitoring MTS packets.
pss Enables debugging for TL port monitoring PSS packets.
interface fc slot/port Restricts debugging to the specified interface.
Release Modification
1.0(2) This command was introduced.
Command Description
no debug all Disables all debugging.
show tlport Displays configured TL port information.

Cisco MDS 9000 Series Specifications

General

Category	Switch
Operating System	Cisco NX-OS
Ports	Varies by model
Protocols	Fibre Channel (FC), Fibre Channel over IP (FCIP), iSCSI
Redundancy	Redundant supervisors, power supplies, and fans
Management	Cisco Data Center Network Manager (DCNM), CLI, SNMP
Virtualization Support	VSANs (Virtual SANs)
Security Features	Fibre Channel Security Protocol (FC-SP)
Hot Swappable Components	power supplies, fans
Power Supply Options	AC and DC options available