Cisco MDS 9000 Series Command Reference

Send documentation comments to mdsfeedback-doc@cisco.com
6-81
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 6 Debug Commands
debug mip
debug mip
To enable debugging for multiple IP (MIP) kernel drivers, use the debug mip command in EXEC mode.
To disable a debug command, use the no form of the command or use the no debug all command to turn
off all debugging.
debug mip {errors | events}
no debug mip {errors | events}
Syntax Description
Defaults Disabled.
Command Modes EXEC mode.
Command History
Usage Guidelines None.
Examples The following example displays the system output when the debug mip errors command is issued:
switch# debug mip errors
Related Commands
errors Enables debugging for MIP error conditions.
events Enables debugging for MIP events.
Release Modification
1.0(2) This command was introduced.
Command Description
no debug all Disables all debugging.

Cisco MDS 9000 Series Specifications

General

Category	Switch
Operating System	Cisco NX-OS
Ports	Varies by model
Protocols	Fibre Channel (FC), Fibre Channel over IP (FCIP), iSCSI
Redundancy	Redundant supervisors, power supplies, and fans
Management	Cisco Data Center Network Manager (DCNM), CLI, SNMP
Virtualization Support	VSANs (Virtual SANs)
Security Features	Fibre Channel Security Protocol (FC-SP)
Hot Swappable Components	power supplies, fans
Power Supply Options	AC and DC options available