Cisco MDS 9000 Series Command Reference

Send documentation comments to mdsfeedback-doc@cisco.com
6-62
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 6 Debug Commands
debug ilc_helper
debug ilc_helper
To enable ILC helper debugging, use the debug ilc_helper command in EXEC mode. To disable a debug
command, use the no form of the command or use the no debug all command to turn off all debugging.
debug ilc_helper {all | errors | events | info}
no debug ilc_helper {all | errors | events | info}
Syntax Description
Defaults Disabled.
Command Modes EXEC mode.
Command History
Usage Guidelines None.
Examples The following example displays the system output when the debug ilc_helper all command is issued:
switch# debug ilc_helper all
For Application :125, sdwrap:mts_send : Broken pipe
Related Commands
all Enables debugging for all ILC helper features.
errors Enables debugging for ILC helper error conditions.
events Enables debugging for the ILC helper events.
info Enables debugging for ILC helper information.
Release Modification
1.0(2) This command was introduced.
Command Description
no debug all Disables all debugging.

Cisco MDS 9000 Series Specifications

General

Category	Switch
Operating System	Cisco NX-OS
Ports	Varies by model
Protocols	Fibre Channel (FC), Fibre Channel over IP (FCIP), iSCSI
Redundancy	Redundant supervisors, power supplies, and fans
Management	Cisco Data Center Network Manager (DCNM), CLI, SNMP
Virtualization Support	VSANs (Virtual SANs)
Security Features	Fibre Channel Security Protocol (FC-SP)
Hot Swappable Components	power supplies, fans
Power Supply Options	AC and DC options available