Cisco MDS 9000 Series Command Reference

Send documentation comments to mdsfeedback-doc@cisco.com
11-23
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 11 I Commands
interface fc
interface fc
To configure a Fibre Channel interface on the Cisco MDS 9000 Family of switches, use the interface fc
command in EXEC mode. To revert to defaults, use the no form of the command.
interface fc slot/port
channel-group {group-id [force] | auto}
fcdomain rcf-reject vsan vsan-id
fspf {cost link-cost vsan vsan-id | ficon portnumber portnumber | dead-interval seconds vsan
vsan-id | hello-interval seconds vsan vsan-id | passive vsan vsan-id | retransmit-interval
seconds vsan vsan-id}
interface fc slot/port
no channel-group {group-id [force] | auto}
no fcdomain rcf-reject vsan vsan-id
no fspf {cost link_cost vsan vsan-id | ficon portnumber portnumber | dead-interval seconds
vsan vsan-id | hello-interval seconds vsan vsan-id | passive vsan vsan-id | retransmit-interval
seconds vsan vsan-id}
Syntax Description
Defaults Disabled.
Command Modes Configuration mode.
slot/port Specifies a slot number and port number.
channel-group Adds to or removes from a Port Channel.
group-id Specifies a Port Channel group number from 1 to 128.
force Forcefully adds a port.
auto Enables autocreation of port channels.
fcdomain Enters the interface submode.
rcf-reject Configures the rcf-reject flag.
vsan vsan-id Specifies the VSAN ID. The range is 1 to 4093.
fspf Configures FSPF parameters.
cost link-cost Configures FSPF link cost. The range is 1 to 65535.
dead-interval seconds Configures FSPF dead interval in seconds. The range is 2 to 65535.
ficon Configures FICON parameters.
portnumber portnumber Configures the FICON port number for this interface.
hello-interval seconds Configures FSPF hello-interval. The range is 1 to 65535.
passive Enables or disables FSPF on the interface.
retransmit-interval
seconds
Configures FSPF retransmit interface in seconds. The range is 1 to 65535.

Cisco MDS 9000 Series Specifications

General

Category	Switch
Operating System	Cisco NX-OS
Ports	Varies by model
Protocols	Fibre Channel (FC), Fibre Channel over IP (FCIP), iSCSI
Redundancy	Redundant supervisors, power supplies, and fans
Management	Cisco Data Center Network Manager (DCNM), CLI, SNMP
Virtualization Support	VSANs (Virtual SANs)
Security Features	Fibre Channel Security Protocol (FC-SP)
Hot Swappable Components	power supplies, fans
Power Supply Options	AC and DC options available