Cisco MDS 9000 Series Command Reference

Send documentation comments to mdsfeedback-doc@cisco.com
25-3
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 25 V Commands
virtual-fcid (SDV virtual device configuration submode)
virtual-fcid (SDV virtual device configuration submode)
To configure a persistent virtual FC ID, use the virtual-fcid command in SDV virtual device
configuration submode. To remove a persistent virtual FC ID, use the the no form of the command.
virtual-fcid fc-id
no virtual-fcid fc-id
Syntax Description
Defaults No virtual FC IDs are configured by default.
Command Modes SDV virtual device configuration submode.
Command History
Usage Guidelines None.
Examples The following example shows how to configure a persistent virtual FC ID.
switch# config terminal
Enter configuration commands, one per line. End with CNTL/Z.
switch(config)# sdv virtual-device name sqa1 vsan 1
switch(config-sdv-virt-dev)# virtual-fcid 0xd66e54
Related Commands
fc-id Specifies the persistent virtual FC ID. The format is 0xhhhhhh, where h is a
hexadecimal number.
Release Modification
3.1(2) This command was introduced.
Command Description
sdv enable Enables or disables SAN device virtualization.
show sdv statistics Displays SAN device virtualization statistics.

Cisco MDS 9000 Series Specifications

General

Category	Switch
Operating System	Cisco NX-OS
Ports	Varies by model
Protocols	Fibre Channel (FC), Fibre Channel over IP (FCIP), iSCSI
Redundancy	Redundant supervisors, power supplies, and fans
Management	Cisco Data Center Network Manager (DCNM), CLI, SNMP
Virtualization Support	VSANs (Virtual SANs)
Security Features	Fibre Channel Security Protocol (FC-SP)
Hot Swappable Components	power supplies, fans
Power Supply Options	AC and DC options available