Cisco MDS 9000 Series

Send documentation comments to mdsfeedback-doc@cisco.com
6-89
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 6 Debug Commands
debug plog
debug plog
To enable debugging of persistent logging (PLOG), use the debug plog command in EXEC mode. To
disable a debug command, use the no form of the command or use the no debug all command to turn
off all debugging.
debug plog {error | trace}
no debug plog {error | trace}
Syntax Description
Defaults Disabled.
Command Modes EXEC mode.
Command History
Usage Guidelines None.
Examples The following example displays the system output when the debug plog command is issued:
switch# debug plog
Related Commands
error Enables debugging of PLOG error conditions.
trace Enables debugging of PLOG events.
Release Modification
3.0(1) This command was introduced.
Command Description
no debug all Disables all debugging.