Cisco MDS 9000 Series Command Reference

Send documentation comments to mdsfeedback-doc@cisco.com
15-2
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 15 M Commands
match
match
To configure QoS class map match criteria, use the match command in class map configuration
submode. Remove QoS class map match criteria, use the no form of the command.
match {any | destination-address fc-id [mask address-mask] | destination-device-alias name |
destination-wwn wwn-id | input-interface fc slot/port | source-address fc-id [mask
address-mask] | source-device-alias name | source-wwn wwn-id}
no match {any | destination-address fc-id [mask address-mask] | destination-device-alias name
| destination-wwn wwn-id | input-interface fc slot/port | source-address fc-id [mask
address-mask] | source-device-alias name | source-wwn wwn-id}
Syntax Description
Defaults None.
Command Modes Class map configuration submode.
Command History
Usage Guidelines You can access this command only if you enable the QoS data traffic feature using the qos enable
command.
Examples The following example creates a class map called MyClass1 and places you in the class map
configuration submode to match any (default) criteria specified for this class.
switch# config terminal
any Enables matching of any frame.
destination-address fc-id Specifies the destination FCID to match frames.
mask address-mask Specifies an address mask to match frames. The range is 0x0 to
0xffffffff.
destination-device-alias name Specifies the destination device alias to match frames. Maximum
length is 64 characters.
destination-wwn wwn-id Specifies the destination WWN to match frames.
input-interface fc slot/port Specifies the source Fibre Channel interface to match frames.
source-address fc-id Specifies the source FCID to match frames.
source-device-alias name Specifies the source device alias to match frames. Maximum length
is 64 characters.
source-wwn wwn-id Specifies the source WWN to match frames.
Release Modification
1.3(1) This command was introduced.
2.0(x) Added the destination-device-alias and source-device-alias options.

Cisco MDS 9000 Series Specifications

General

Category	Switch
Operating System	Cisco NX-OS
Ports	Varies by model
Protocols	Fibre Channel (FC), Fibre Channel over IP (FCIP), iSCSI
Redundancy	Redundant supervisors, power supplies, and fans
Management	Cisco Data Center Network Manager (DCNM), CLI, SNMP
Virtualization Support	VSANs (Virtual SANs)
Security Features	Fibre Channel Security Protocol (FC-SP)
Hot Swappable Components	power supplies, fans
Power Supply Options	AC and DC options available