Cisco MDS 9000 Series Command Reference

Send documentation comments to mdsfeedback-doc@cisco.com
15-3
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 15 M Commands
match
switch(config)# qos class-map MyClass1 match-any
switch(config-cmap)# match any
The following example specifies a destination address match for frames with the specified destination
FCID.
switch(config-cmap)# match destination-address 0x12ee00
The following example specifies a source address and mask match for frames with the specified source
FCID. Mask refers to a single or entire area of FCIDs.
switch(config-cmap)# match source-address 0x6d1090 mask 0
The following example specifies a destination WWN to match frames.
switch(config-cmap)# match destination-wwn 20:01:00:05:30:00:28:df
Operation in progress. Please check class-map parameters
The following example specifies a source WWN to match frames.
switch(config-cmap)# match source-wwn 23:15:00:05:30:00:2a:1f
Operation in progress. Please check class-map parameters
The following example specifies a source interface to match frames.
switch(config-cmap)# match input-interface fc 2/1
Operation in progress. Please check class-map parameters
The following example removes a match based on the specified source interface.
switch(config-cmap)# no match input-interface fc 3/5
Related Commands Command Description
qos enable Enables QoS.
show qos Displays QoS information.

Cisco MDS 9000 Series Specifications

General

Category	Switch
Operating System	Cisco NX-OS
Ports	Varies by model
Protocols	Fibre Channel (FC), Fibre Channel over IP (FCIP), iSCSI
Redundancy	Redundant supervisors, power supplies, and fans
Management	Cisco Data Center Network Manager (DCNM), CLI, SNMP
Virtualization Support	VSANs (Virtual SANs)
Security Features	Fibre Channel Security Protocol (FC-SP)
Hot Swappable Components	power supplies, fans
Power Supply Options	AC and DC options available