Send documentation comments to mdsfeedback-doc@cisco.com
11-104
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 11 I Commands
islb save-initiator
islb save-initiator
To permanently save the automatically-assigned nWWN/pWWN mapping for the iSLB initiator, use the
islb save-initiator command.
islb save-initiator [ip-address ip-address | name name]
Syntax Description
Defaults None.
Command Modes Configuration mode.
Command History
Usage Guidelines Saving the automatically assigned nWWN/pWWN mapping allows the initiator to use the same mapping
the next time it logs in.
You can convert a dynamic iSLB initiator to a static iSLB initiator and make its WWNs persistent.
Note You cannot convert a dynamic iSCSI initiator to a static iSLB initiator or a dynamic iSLB initiator to a
static iSCSI initiator.
Note Making the dynamic mapping for iSLB initiators static is the same as for iSCSI.
Note Only a statically mapped iSLB initiator configuration is distributed throughout the fabric using CFS.
Dynamically and statically configured iSCSI initiator configurations are not distributed.
Examples The following example saves the nWWNs and pWWNs that have automatically been assigned to the
iSLB initiator whose name is specified.
switch# config t
switch(config)# islb save-initiator name iqn.1987-02.com.cisco.initiator
The following example saves the nWWNs and pWWNs that have automatically been assigned to the
iSLB initiator whose IPv4 address is specified.
switch(config)# islb save-initiator ip-address 10.10.100.11
ip-address ip-address Specifies the initiator IP address. The format is A.B.C.D or X:X:X::X.
name name Specifies the initiator name to be used from 1 to 223 characters.
Release Modification
3.0(1) This command was introduced.
To Next Page
Loading...
Need help?
General
