Cisco MDS 9000 Series Command Reference

Send documentation comments to mdsfeedback-doc@cisco.com
12-2
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 12 J Commands
job name
job name
To assign a job to a command schedule, use the job name command. To remove the job, use the no form
of the command.
job name job-name
no job name job-name
Syntax Description
Defaults None.
Command Modes Scheduler schedule configuration submode.
Command History
Usage Guidelines To use this command, the command scheduler must be enabled using the scheduler enable command.
You can configure multiple jobs in a command schedule.
Examples The following example shows how to specified the job for a command schedule.
switch# config terminal
switch(config)# scheduler schedule name MySchedule
switch(config-schedule)# job name MyJob
Related Commands
job-name Specifies the job name for the command schedule to run.
Release Modification
2.0(x) This command was introduced.
Command Description
scheduler enable Enables the command scheduler.
scheduler schedule name Configures a schedule for the command scheduler.
show scheduler Displays scheduler information.

Cisco MDS 9000 Series Specifications

General

Category	Switch
Operating System	Cisco NX-OS
Ports	Varies by model
Protocols	Fibre Channel (FC), Fibre Channel over IP (FCIP), iSCSI
Redundancy	Redundant supervisors, power supplies, and fans
Management	Cisco Data Center Network Manager (DCNM), CLI, SNMP
Virtualization Support	VSANs (Virtual SANs)
Security Features	Fibre Channel Security Protocol (FC-SP)
Hot Swappable Components	power supplies, fans
Power Supply Options	AC and DC options available