Cisco MDS 9000 Series Command Reference

Send documentation comments to mdsfeedback-doc@cisco.com
14-11
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 14 L Commands
link-state-trap
link-state-trap
To enable an SNMP link state trap on an interface, use the link-state-trap command in interface
configuration submode. To disable an SNMP link state trap, use the no form of the command.
link-state-trap
no link-state-trap
Syntax Description This command has no arguments or keywords.
Defaults Enabled.
Command Modes Interface configuration submode.
Command History
Usage Guidelines None.
Examples The following example shows how to enable an SNMP link state trap on interface bay2.
switch# config terminal
Enter configuration commands, one per line. End with CNTL/Z.
switch(config)# interface bay 2
switch(config-if)# link-state-trap
The following example shows how to disable an SNMP link state trap on interface bay2.
switch# config terminal
Enter configuration commands, one per line. End with CNTL/Z.
switch(config)# interface bay 2
switch(config-if)# no link-state-trap
Related Commands
Release Modification
3.1(2) This command was introduced.
Command Description
show interface Displays interface information.

Cisco MDS 9000 Series Specifications

General

Category	Switch
Operating System	Cisco NX-OS
Ports	Varies by model
Protocols	Fibre Channel (FC), Fibre Channel over IP (FCIP), iSCSI
Redundancy	Redundant supervisors, power supplies, and fans
Management	Cisco Data Center Network Manager (DCNM), CLI, SNMP
Virtualization Support	VSANs (Virtual SANs)
Security Features	Fibre Channel Security Protocol (FC-SP)
Hot Swappable Components	power supplies, fans
Power Supply Options	AC and DC options available