Cisco MDS 9000 Series Command Reference

Send documentation comments to mdsfeedback-doc@cisco.com
21-60
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 21 S Commands
switch-priority
switch-priority
To configure the switch priority with the Call Home function, use the switch-priority command in Call
Home configuration submode. To disable this feature, use the no form of the command.
switch-priority {priority-value}
no switch-priority {priority-value}
Syntax Description
Defaults None.
Command Modes Call Home configuration submode.
Command History
Usage Guidelines None.
Examples The following example shows how to configure the switch priority in the Call Home configuration.
switch# config terminal
Enter configuration commands, one per line. End with CNTL/Z.
switch(config)# callhome
switch(config-callhome)# switch-priority 0
Related Commands
priority-value Specifies the priority level. 0 is the highest priority and 7 the lowest.
Release Modification
1.0(2) This command was introduced.
Command Description
callhome Configures the Call Home function.
callhome test Sends a dummy test message to the configured destination(s).
show callhome Displays configured Call Home information.

Cisco MDS 9000 Series Specifications

General

Category	Switch
Operating System	Cisco NX-OS
Ports	Varies by model
Protocols	Fibre Channel (FC), Fibre Channel over IP (FCIP), iSCSI
Redundancy	Redundant supervisors, power supplies, and fans
Management	Cisco Data Center Network Manager (DCNM), CLI, SNMP
Virtualization Support	VSANs (Virtual SANs)
Security Features	Fibre Channel Security Protocol (FC-SP)
Hot Swappable Components	power supplies, fans
Power Supply Options	AC and DC options available