Send documentation comments to mdsfeedback-doc@cisco.com
1-26
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 1 CLI Overview
Searching and Filtering CLI Output
Setting the Switch’s Shell Timeout
Use the exec-timeout command in configuration mode to configure the lifetime of all terminal sessions
on that switch. When the time limit configured by this command is exceeded, the shell exits and closes
that session. The syntax for this command from is exec-timeout minutes
The default is 30 minutes. You can configure different timeout values for a console or a virtual terminal
line (VTY) session. You can set the exec-timeout value to 0 to disable this feature so the session remains
active until you exit the switch. This change is saved in the configuration file.
• From the console:
switch(config)# line console
switch(config-console)# exec-timeout 60
Specifies the current console shell timeout to be 60 minutes.
• From a VTY session (Telnet or SSH):
switch(config)# line vty
switch(config-line)# exec-timeout 60
Specifies the current console shell timeout to be 60 minutes.
Displaying VTY Sessions
Use the show line command to display all configured VTY sessions:
switch# show line
line Console:
Speed: 9600 bauds
Databits: 8 bits per byte
Stopbits: 1 bit(s)
Parity: none
Modem In: Disable
Modem Init-String -
default : ATE0Q1&D2&C1S0=1\015
Statistics: tx:5558511 rx:5033958 Register Bits:RTS|CTS|DTR|DSR|CD|RI
line Aux:
Speed: 9600 bauds
Databits: 8 bits per byte
Stopbits: 1 bit(s)
Parity: none
Modem In: Disable
Modem Init-String -
default : ATE0Q1&D2&C1S0=1\015
Hardware Flowcontrol: ON
Statistics: tx:35 rx:0 Register Bits:RTS|DTR
Clearing VTY Sessions
Use the clear line command to close a specified VTY session:
switch# clear line Aux
To Next Page
Loading...
Need help?
General
