Cisco MDS 9000 Series Command Reference

Send documentation comments to mdsfeedback-doc@cisco.com
21-39
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 21 S Commands
snmp-server tcp-session
snmp-server tcp-session
To enable one time authentication for SNMP over a TCP session, use the snmp-server tcp-session
command in configuration mode. To disable one time authentication for SNMP over a TCP session, use
the no form of the command.
snmp-server tcp-session [auth]
no snmp-server tcp-session [auth]
Syntax Description
Command Default One time authentication for SNMP over a TCP session is on.
Command Modes Configuration mode.
Command History
Usage Guidelines None.
Examples The following example enables one time authentication for SNMP over a TCP session.
switch# config t
Enter configuration commands, one per line. End with CNTL/Z.
switch(config)# snmp-server tcp-session auth
Related Commands
auth Enables one time authentication for SNMP over a TCP session.
Release Modification
3.1 This command was introduced.
Command Description
show snmp Displays SNMP information.

Cisco MDS 9000 Series Specifications

General

Category	Switch
Operating System	Cisco NX-OS
Ports	Varies by model
Protocols	Fibre Channel (FC), Fibre Channel over IP (FCIP), iSCSI
Redundancy	Redundant supervisors, power supplies, and fans
Management	Cisco Data Center Network Manager (DCNM), CLI, SNMP
Virtualization Support	VSANs (Virtual SANs)
Security Features	Fibre Channel Security Protocol (FC-SP)
Hot Swappable Components	power supplies, fans
Power Supply Options	AC and DC options available