Cisco MDS 9000 Series Command Reference

Send documentation comments to mdsfeedback-doc@cisco.com
4-49
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 4 C Commands
clear ips arp
clear ips arp
To clear ARP caches, use the clear ips arp command in EXEC mode.
clear ips arp {address ip-address| interface gigabitethernet module-number}
Syntax Description
Defaults None.
Command Modes EXEC.
Command History
Examples The ARP cache can be cleared in two ways: clearing just one entry or clearing all entries in the ARP
cache.
The following example clears one ARP cache entry:
switch# clear ips arp address 10.2.2.2 interface gigabitethernet 8/7
arp clear successful
The following example clears all ARP cache entries
switch# clear ips arp interface gigabitethernet 8/7
arp clear successful
address Clears fcflow aggregated statistics.
ip-address Enters the peer IP address.
interface
gigabitethernet
Specifies the Gigabit Ethernet interface.
module-number Specifies slot and port of the Gigabit Ethernet interface.
Release Modification
1.1(1) This command was introduced.

Cisco MDS 9000 Series Specifications

General

Category	Switch
Operating System	Cisco NX-OS
Ports	Varies by model
Protocols	Fibre Channel (FC), Fibre Channel over IP (FCIP), iSCSI
Redundancy	Redundant supervisors, power supplies, and fans
Management	Cisco Data Center Network Manager (DCNM), CLI, SNMP
Virtualization Support	VSANs (Virtual SANs)
Security Features	Fibre Channel Security Protocol (FC-SP)
Hot Swappable Components	power supplies, fans
Power Supply Options	AC and DC options available