Cisco MDS 9000 Series Command Reference

Send documentation comments to mdsfeedback-doc@cisco.com
11-125
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 11 I Commands
ivr enable
ivr enable
To enable the Inter-VSAN Routing (IVR) feature, use the ivr enable command in configuration mode.
To disable this feature, use the no form of the command.
ivr enable
no ivr enable
Syntax Description This command has no arguments or keywords.
Defaults Disabled.
Command Modes Configuration mode.
Command History
Usage Guidelines The IVR feature must be enabled in all edge switches in the fabric that participate in the IVR.
The configuration and display commands for the IVR feature are only available when IVR is enabled on
a switch.
When you disable this configuration, all related configurations are automatically discarded.
Note This command is not supported on the Cisco MDS 9124 switch, the Cisco Fabric Switch for HP c-Class
BladeSystem, and the Cisco Fabric Switch for IBM BladeCenter.
Examples The following command enters the configuration mode and enables the IVR feature on this switch.
switch# config terminal
Enter configuration commands, one per line. End with CNTL/Z.
switch(config)# ivr enable
Related Commands
Release Modification
1.3(1) This command was introduced.
Command Description
show ivr Displays IVR feature information.

Cisco MDS 9000 Series Specifications

General

Category	Switch
Operating System	Cisco NX-OS
Ports	Varies by model
Protocols	Fibre Channel (FC), Fibre Channel over IP (FCIP), iSCSI
Redundancy	Redundant supervisors, power supplies, and fans
Management	Cisco Data Center Network Manager (DCNM), CLI, SNMP
Virtualization Support	VSANs (Virtual SANs)
Security Features	Fibre Channel Security Protocol (FC-SP)
Hot Swappable Components	power supplies, fans
Power Supply Options	AC and DC options available