Cisco MDS 9000 Series Command Reference

Send documentation comments to mdsfeedback-doc@cisco.com
6-111
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 6 Debug Commands
debug sensor
debug sensor
To enable debugging for the sensor manager, use the debug sensor command in EXEC mode. To disable
a debug command, use the no form of the command or use the no debug all command to turn off all
debugging.
debug sensor {demux | deque | error | info | init}
no debug sensor {demux | deque | error | info | init}
Syntax Description
Defaults Disabled.
Command Modes EXEC mode.
Command History
Usage Guidelines Use this command to debug sensor manager events and information.
Examples The following example displays the system output when the debug sensor info command is issued:
switch# debug sensor info
Related Commands
demux Enables debugging for sensor demux functions.
deque Enables debugging for sensor deque events.
error Enables debugging for sensor errors.
info Enables debugging for sensor information.
init Enables debugging for sensor initialization.
Release Modification
1.0(2) This command was introduced.
Command Description
no debug all Disables all debugging.
show environment temperature Displays current temperature threshold settings and state.

Cisco MDS 9000 Series Specifications

General

Category	Switch
Operating System	Cisco NX-OS
Ports	Varies by model
Protocols	Fibre Channel (FC), Fibre Channel over IP (FCIP), iSCSI
Redundancy	Redundant supervisors, power supplies, and fans
Management	Cisco Data Center Network Manager (DCNM), CLI, SNMP
Virtualization Support	VSANs (Virtual SANs)
Security Features	Fibre Channel Security Protocol (FC-SP)
Hot Swappable Components	power supplies, fans
Power Supply Options	AC and DC options available