Cisco MDS 9000 Series Command Reference

Send documentation comments to mdsfeedback-doc@cisco.com
14-9
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 14 L Commands
line vty
line vty
To configure a virtual terminal line, use the line vty command. To negate the previously issued command
or to revert to factory defaults, use the no form of the command.
line vty -->
exec-timeout minutes |
session-limit number
line vty -->
no exec-timeout |
no session-limit number
Syntax Description
Defaults None.
Command Modes Configuration mode.
Command History
Usage Guidelines The line vty command available in config t command mode. line vty configuration commands available
in config-line submode.
Examples The following example configures a virtual terminal line and sets the timeout for that line.
switch## config terminal
switch(config)# line vty
switch(config-line)# exec-timeout 60
Related Commands
exec-timeout minutes Configures timeout in minutes. The range is 0 to 525600. To disable, set to 0
minutes.
session-limit number Configures the number of VSH sessions. The range is 1 to 64.
Release Modification
1.0(2) This command was introduced.
Command Description
line console Configure primary terminal line.
line com1 Confgiures the auxiliary COM 1 port

Cisco MDS 9000 Series Specifications

General

Category	Switch
Operating System	Cisco NX-OS
Ports	Varies by model
Protocols	Fibre Channel (FC), Fibre Channel over IP (FCIP), iSCSI
Redundancy	Redundant supervisors, power supplies, and fans
Management	Cisco Data Center Network Manager (DCNM), CLI, SNMP
Virtualization Support	VSANs (Virtual SANs)
Security Features	Fibre Channel Security Protocol (FC-SP)
Hot Swappable Components	power supplies, fans
Power Supply Options	AC and DC options available