Cisco MDS 9000 Series Command Reference

Send documentation comments to mdsfeedback-doc@cisco.com
11-27
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 11 I Commands
interface fcip
interface fcip
To configure a Fibre Channel over IP Protocol (FCIP) interface, use the interface fcip command. To
disable a FCIP interface, use the no form of the command.
interface fcip interface_number
bport
bport-keepalives
channel-group number [force]
fcdomain rcf-reject vsan vsan-id
ficon portnumber portnumber |
fspf {cost link-cost | dead-interval seconds | hello-interval seconds | passive |
retransmit-interval seconds} vsan vsan-id
passive-mode
peer-info ipaddr ip-address [port number]
qos control control-value data data-value
special-frame peer-wwn pwwn-id
tcp-connections number
time-stamp [acceptable-diff number]
use-profile profile-id
interface fcip interface_number
no bport
no bport-keepalives
no channel-group number [force]
no fcdomain rcf-reject vsan vsan-id
no ficon portnumber portnumber
no fspf {cost link-cost | dead-interval seconds | hello-interval seconds | passive |
retransmit-interval seconds} vsan vsan-id
no qos control-value data data-value
no passive-mode
no peer-info ipaddr ip-address [port number]
no special-frame peer-wwn pwwn-id
no tcp-connections number
no time-stamp [acceptable-diff number]
no use-profile profile-id
Syntax Description interface-number Configures the specified interface from 1 to 255.
bport Sets the B port mode.
bport-keepalives Sets the B port keepalive responses.
channel-group number Specifies a PortChannel number from 1 to 128.
force Forcefully adds a port.
fcdomain Enters the fcdomain mode for this FCIP interface
rcf-reject Configures the rcf-reject flag.
vsan vsan-id Specifies a VSAN ID. The range is 1 to 4093.
fspf Configures FSPF parameters.
cost link-cost Enters FSPF link cost. The range is 1 to 65535
dead-interval seconds Specifies the dead interval in seconds. The range is 1 to 65535.

Cisco MDS 9000 Series Specifications

General

Category	Switch
Operating System	Cisco NX-OS
Ports	Varies by model
Protocols	Fibre Channel (FC), Fibre Channel over IP (FCIP), iSCSI
Redundancy	Redundant supervisors, power supplies, and fans
Management	Cisco Data Center Network Manager (DCNM), CLI, SNMP
Virtualization Support	VSANs (Virtual SANs)
Security Features	Fibre Channel Security Protocol (FC-SP)
Hot Swappable Components	power supplies, fans
Power Supply Options	AC and DC options available