Cisco MDS 9000 Series

Send documentation comments to mdsfeedback-doc@cisco.com
6-9
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 6 Debug Commands
debug cert-enroll
debug cert-enroll
To enable debugging for the certificate enroll daemon, use the debug cert-enroll command in EXEC
mode. To disable a debug command use the no form of the command or use the no debug all command
to turn off all debugging.
debug cert-enroll {all | config | config-lowlevel | request | request-lowlevel}
no debug cert-enroll {all | config | config-lowlevel | request | request-lowlevel}
Syntax Description
Defaults Disabled.
Command Modes EXEC mode.
Command History
Usage Guidelines None.
all Enables all debugging flags.
config Enables debugging for the certificate enroll configuration.
config-lowlevel Enables low-level debugging for the certificate enroll configuration
request Enables debugging for the certification enroll request.
request-lowlevel Enables low-level debugging for the certification enroll request.
Release Modification
3.0(1) This command was introduced.